1. Cementation of metal, resin, all ceramic and ceramic based inlays, onlays, bridges and crowns.
2. Cementation pins, posts and screws
Low film thickness - 17micron
Shear bond strength to zirconia - 6.9 MPa
Shear bond strength to dentin - 11.7MPa.
1. Select the appropriate shade of ‘seT PP’.
2. Remove the temporary restoration and clean the preparation
thoroughly using an oil free pumice to remove any remaining
temporary cement (NOTE: temporary restoration should only be
seated with eugenol-free cement).
3. Try in the restoration.
4. Again, clean with water and dry, but DO NOT DESICCATE.
WARNING: In cases where pulp protection is necessary, use a hard
setting calcium hydroxide liner before the final impression is made.
Substances such as hydrogen peroxide, desensitizers, disinfectants,
astringents and dentin sealants etc should not be used as residues
may interfere with bond strength and setting reactions.
Clean thoroughly and prepare the restoration according to
PREPARATION OF SYRINGE:
Remove cap. Dispense 2-3mm of material onto a pad and discard (to
ensure correct ratio of extrusion). Attach a mixing tip to the syringe.
MIXING BY HAND:
Without mixing tip attached, extrude even amount of material onto
mixing pad. With a suitable spatula mix the two pastes together for
APPLICATION of ‘seT PP’
1. Protect the work area against contamination from intra-oral fluids.
2. Place or extrude ‘seT PP’ evenly onto all bonding surfaces of the
restoration and tooth.
NOTE: Do not use Lentulo-Spirals to insert the
cement into root canals, as this can excessively accelerate setting.
Also to avoid entrapping air, vibrate posts while inserting into root
NOTE: In the case of veneers, use an adhesive (Go!, Stae, etc
according to manufacturer’s instructions including any etching
procedure) prior to seT PP to improve the retentive strength.
Cement only 1-2 veneers at a time due to limitation of the paste’s
working time (WT - 2 minutes, ST - 5 minutes,
Light-curing time - 20 seconds)
Note: These times are approximate only, and may vary based on
storage conditions, humidity, age of product and temperature
3. Seat restoration, and leave for 30 seconds before any light curing is
4. Trim excess material away after light curing for 2 seconds or after 2
minutes from start of mixing.
NOTE: If excess cement is removed with a sponge pellet or a similar
implement leave a minimal amount of excess after restoration is
seated. Immediately after, either briefly light-cure the excess or if
allowing to self-cure cover the excess with glycerine gel to prevent
5. Light cure thoroughly to speed up setting process (minimum 20
seconds per surface). In the case of composite and all ceramic
materials, light cure ‘seT PP’ through the restoration.
6. Polish marginal area.
1. Avoid excess heat. For optimum performance,
refrigeration of the product is recommended.
2. Store at temperatures between 2° and 25°C (35° - 77°F).
3. For optimum freshness, refrigeration is optional.
4. Use at room temperature between 20° and 25°C (68° - 77°F)